Technical data

Manual
Double Sheet Detector R1000 series E20
B0046991 / Rev. 1.6
Start-up
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
109
7.7 System parameters
Note The selected system configuration should be documented in the form
“System configuration“ in the chapter 13.2. This information is required in
case a system needs to be exchanged.
The general adjustments are specified in the system parameters.
For accessing, select the “system parameter configuration“ mode and confirm with ENTER.
System parameter 1: Setting the dialogue language.
Fig. 54: Selecting the dialogue language
System parameter 2: Specifying the type of sensor.
Fig.. 55: Specifying the type of sensor
Currently available sensors:
• P30
• P36
• P42
• P42A
• P75
• P75V
System parameter 3: Selecting the dimensions for the display (mm / inch).
When changing the measurement dimensions, then the sheet metal thicknesses of the stored
program parameters are also converted into the new dimension. In addition, %mm and %inch are
also available.
Fig.. 56: Selecting the dimension for the display
system param. 3
Dimension: mm
system param. 1
language:english
system param. 2
sensor type:P42A