Technical data

Manual
Double Sheet Detector R1000 series E20
Operation
B0046991 / Rev. 1.6
116
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
In the measuring mode the measured value can be read in the display. The control unit
automatically compares the measured value with the adjusted thresholds. The result is transmitted
via the interface to the PLC and also to the front panel LED's.
During the normal measurement process no further actions on the control units are necessary with
the following few exceptions. The following situations require action directly at the control unit or an
action via the field bus interface:
• Clear fault and error messages (see to chapter “9. Error messages, causes and remedies“)
• Teaching of new types of metal and sheet metal thicknesses (see section “7.6 Configuration
of the program parameters“)
The following notes for the measuring operations should be observed:
Note If the measured value fluctuates and deviates substantially from nominal
value during normal operation then an air gap between sensor and sheet
surface is the most likely cause. A renewed Teach in cannot overcome
this problem.
Note Do not adjust the upper limit (“up“) above 120 %.
Pos: 64 /Doppel blech/Geräte/E2 0 Bus/8 Betri eb/Messprogr amm anlegen @ 0\mod_1173 279301750_5 01.doc @ 3254 @ 2 @ 1
8.2 Entering a measurement program
1 Push the MENU key, switch to "change" with the ↑ ↓ keys and confirm with ENTER key
2 Enter the password
3 Switch to "program parameter" and confirm with ENTER key
4 Select the desired program number at the control unit
5 In of case of a 4P control unit is, select the appropriate sensor
6 Enter the nominal dimension (nominal thickness of the sheet to be processed)
7 Adjust lower limit (“low“) to 80% (default setting)
8 Adjust upper limit (“up“) to 120% (default setting)
9 Return into the measurement mode with the MENU key
Pos: 65 /Doppel blech/Geräte/E2 0 Bus/8 Betri eb/Nullabgleich durchführen @ 0\mod_11732 79413765_50 1.doc @ 3259 @ 2 @ 1