Technical data

Manual
Double Sheet Detector R1000 series E20
B0046991 / Rev. 1.6
Operation
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
117
8.3 Zero adjust
1 Push the MENU key, switch to "change" with the ↑ ↓ key and confirm with the ENTER key
2 Enter the password
3 Switch to "program parameter" and confirm with ENTER key
4 Select the desired program number at the control unit
5 Switch to zero adjust (parameter 6)
6 Select "zero adjust" and confirm with ENTER key
7 The message "remove sheet" appears, then confirm with ENTER key
8 After the message "zero adjust active" the message "zero adjust completed" is shown.
Then confirm with ENTER key
9 Return into the measurement mode with the MENU key
Pos: 66 /Doppel blech/Geräte/E2 0 Bus/8 Betri eb/Teach-In durchführen @ 0\m od_117327 9501234_501.d oc @ 3264 @ 2 @ 1
8.4 Teach-in
1 Push the MENU key, switch to "change" with the ↑ ↓ key and confirm with the ENTER key
2 Enter the password
3 Switch to "program parameter" and confirm with ENTER key
4 Select the desired program number at the control unit
5 Switch to teach-in (parameter 7)
6 Select "teach-in" and confirm with ENTER key
7 The message "attach sheet" appears, then confirm with ENTER key
8 After "teach-in active" the message "Teach in value: x.xx" is shown – the value can be
corrected with the ↑ ↓ keys (the adjustment is not possible if "%mm" or "%inch" were selected
in the configuration menu option 2)
9 Return to the measurement mode with the MENU key
Attention The actual measured value cannot deviate too far from the nominal
dimension, otherwise the fault message "teach-in fault" appears.
(this restriction is not valid if in the configuration option 2 "%mm" or
"%inch" were selected).
The exact teach-in procedure is described in the chapter “7.6 Program parameter 7: teach-in".
Example: Nominal thickness 2.00 mm – manual Teach-in
• The micrometer measures actual value to be: 1.92 mm.
• The teaching shows a value of: 1.89 mm.
• The display value is now corrected to 1.92 mm.
Pos: 67 /Kompo nenten allge mein/Leerseite @ 0\mod_11652 23317234_501. doc @ 2343 @ @ 1