Technical data

Manual
Double Sheet Detector R1000 series E20
Mounting
B0046991 / Rev. 1.6
58
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
4.3.5 Spring loaded sensor bracket SHS42G-FB (with bellow suction cup)
The spring loaded sensor bracket SHS42G-FB with bellow suction cup is intended for the
installation of the P sensor. It is well suitable for use in robotic destackers, since transversal forces
(appearing on fast turning motions) are well compensated.
The suction vacuum and the integrated nap ring assure a full-area pressure contact of sensor and
sheet.
The suction cup has a Shore hardness of 45 (red), harder suction cups with a Shore hardness of
60 (black) are available (see chapter 12 „Order data - sensors and accessories).
On installing, attention must be paid that the sensor is thoroughly sealed (e.g. with Teflon tape) in
the thread seating.
Considerations:
• The sensor face must align with the naps.
• The vacuum must adequately effect.
• The suction facility must be kept free from loading, i.e. the springs may only be low pre-
tensioned.
• The suction facility must not be used as load-lifting device.
Beiliegend:
Schwenkbarer Winkelanschluß
für Schlauch
innen Ø6 mm, aussen Ø8 mm
: unbelastet 128±1
: unbelastet 90±1
: Federweg: ca. 37
1
2
3
60,5
39,5
6
9
,
5
33
Ø
21
Ø
8
4
,
5
M
4
2
x
1
,
5
1
0
x
4
5
,
0
°
M
4
2
x
1
,
5
110
130
70
50
A-A
38
65,5
Ø102
Ø85
15
Ø
9
9
20
Abb. 27: Sensor bracket SHS42G-FB
Pos: 34 /Doppel blech/Sensor en/Sensorhalteru ngen/Klemm vorrichtung SHK @ 1\mod_12 15005517687 _501.doc @ 6 429 @ 3 @ 1