Technical data

Manual
Double Sheet Detector R1000 series E20
B0046991 / Rev. 1.6
Electrical installation
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone [phone] · Fax [phone]
63
5 Electrical installation
Pos: 38 /Doppel blech/Geräte/E2 0/5 Elektrisc he Installation/El ektrische Inst allation - allg emein @ 1\mod_1 19244867167 1_501.doc @ 4826 @ 23 @ 1
5.1 General instructions
The sensor cables should be kept as short as possible in order to minimize the influence of
electromagnetic noise. Cable shields must be connected according to the connection diagrams
only and should not have any additional connections.
Attention Damaged cable installations can result in additional electrical
connections. This can disturb the measured values.
The voltage supply cable should be kept short. Up to 20 m length use cable leads with 2 x 1 mm
2
cross-section. For larger lengths the cross section should be increased.
Pos: 39 /Doppel blech/Geräte/E2 0/5 Elektrisc he Installation/B elegung der P G-Verschraub ungen @ 1\mod _1192448672 937_501.doc @ 4832 @ 233 33344444333 @ 1
5.2 Allocation of connectors
5.2.1 Allocation of connectors at the E20
RS232
Power
PG9
SPS / PLC
PG16
Sensor
PG11 EMV
Fig. 30: Allocation of connectors at the E20