Setup guide

22
3. Assembling and Installing
Step 1: Assembling the Stand – Mounting the Machine
WARNING
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
CAUTION
Unpacking and installation must be carried out by six or more person-
nel.
Otherwise the machine or the stand may fall, resulting in injury.
Procedure

Attach the stand legs to the stand stay.
Place the stand legs with its horseshoe shaped bracket facing inside, and secure them by tightening the
bolts in the order given below. (8 locations in total) Loose bolts may cause the stand to wobble.
Lightly tighten the bolts in the upper 2 locations. (4 locations in total for right and
left)
Lightly tighten the bolts in the 2 locations on the side. (4 locations in total for right
and left)
Fully tighten the bolts in the upper 2 locations. (4 locations in total for right and
left)
Fully tighten the bolts in the 2 locations on the side. (4 locations in total for right
and left)
Place the stand stay as shown in the gure below.
Stand leg
Horseshoe
shaped bracket
Stand stay
Bolts
Hexagonal
wrench
Bolts
Hexagonal
wrench
Stand leg
Stand stay
Side view
Make this area
equally spaced.
Stand leg
Stand stay
Top view
Align them parallel
to each other
Place the leg with the horseshoe shaped bracket facing inward.