Linear Wave Sampler Owner's Manual

7. Produce sound on the device that’s connected to the SP-404SX, and Press the [REC] button when you want to

start sampling.

[REC] button will light, and

sampling will begin.

NOTE

Never turn o the power while sampling is in progress. If you turn o the power, not only the sample being recorded but

also other samples may also be destroyed.

8. When you want to stop sampling, press the [REC] button.

[REC] button will go out, and

sampling will end.

If the display indicates “ F UL ”

In the following cases, the display will indicate “FUL,” and sampling will end automatically.

• When there is no remaining free space on the SD card

• When the sample currently being recorded exceeds 2 GB (approximately 180 minutes in stereo)

9. Press the pad [1] to play back the sound you just sampled.

If the sample included an unwanted portion

If there is unwanted sound or silence at the beginning or end of the sample, you can make settings so that only the

desired portion will be heard.

For details, refer to”Adjusting the Playback Region of a Sample” (p. 27).

If you want to re-record the sample

Delete the sample as described in “Deleting a Sample” (p. 21) on the following page, and then re-record the sample.