User Manual

11
Basic Operation
Turning the Power On and O
Once everything is properly connected (p. 8–10), be
sure to follow the procedure below to turn on their
power. If you turn on equipment in the wrong order,
you risk causing malfunction or equipment failure.
* Before turning the unit on/o, always be sure to turn the
volume down. Even with the volume turned down, you
might hear some sound when switching the unit on/o.
However, this is normal and does not indicate a malfunction.
Turning the power on
1. Make sure all devices are turned o.
2. Press the [POWER] button on the rear panel of
the V-1HD to turn on the power.
* This unit is equipped with a
protection circuit. A brief interval
(a few seconds) after turning the
unit on is required before it will
operate normally.
3. Turn on the power for the source devices.
Turn on the power to video cameras or
other source equipment connected to input
connectors on the V-1HD.
4. Turn on the power for the output devices.
Turn on the power to projectors or other devices
connected to output connectors on the V-1HD.
Turning the power o
1. Turn o the power in the sequence of rst the
output equipment, and then the sources.
2. Press the [POWER] button on the V-1HD to turn
o the power.
MEMO
5 The power to the V-1HD turns o automatically if
a set interval elapses with no operation performed
(Auto O function).
If you don’t want the power to be turned o
automatically, disengage the Auto O function. For
details, refer to “Turning O the Power Automatically
(Auto O)” on this page.
Turning O the Power Automatically (Auto O)
Auto O is a feature that automatically turns o the
power after no operation for a specic period of
time. This helps prevent wasting electrical power.
By factory default, the Auto O function is set on.
When the states described below persist for 240
minutes, the Auto O function acts to automatically
turn o the power.
5 No operation performed on the V-1HD
5 No audio or video input
To turn the Auto O function o or on, follow the
steps below to change the setting.
1. Press and hold the [(TAP) BPM] button (for 2
seconds or longer) to display the SETUP menu.
2. Use the [ ] and [ ] buttons to select “AUTO OFF.”
3. Use the A/B fader to set the Auto O function
on or o.
Value Explanation
ON
The Auto O function is turned on. Power is
turned o automatically.
OFF
The Auto O function is turned o. Power is
not turned o automatically.
4. Press the [(TAP) BPM] button to quit the menu.
* Any settings that you are in the process of editing will
be lost when the power is turned o. If you have any
settings that you want to keep, you should save them
beforehand.
* When the power has been turned o by the Auto O
function, to restart, rst press the [POWER] button to
return it to the O position, then turn on the power.
Executing/changing specic functions at startup
You can execute or change the following functions
at startup of the V-1HD.
Operation at startup Operation
Returning settings to the factory-default state at startup (p. 29) Hold down the [
] and [ ] buttons and press the [POWER] button.
Setting “HDCP” on the SETUP menu to “ON” at startup (p. 15) Hold down the EFFECTS A [ON] button and press the [POWER] button.
Setting “HDCP” on the SETUP menu to “OFF” at startup (p. 15) Hold down the EFFECTS B [ON] button and press the [POWER] button.