User guide

105
Basic operation of the VariOS
Selecting a sample
* When the VariOS has just been powered up, it is not ready to produce sound. You must load samples into
its internal memory. Before you continue with the following procedure, you must use the V-Producer’s
“Load Wave Files” command to send samples to the VariOS (p. 56).
1. Press the [MENU] button so it’s not lighted. The sample select screen will appear.
fig.042-004
2. Make sure that the cursor is located at the sample number, and turn the [VALUE] knob to select
the desired sample.
fig.042-0042
3. You can press the [VOLUME] knob to preview (audition) the selected sample.
* If there is no sample, the display will indicate “NO WAVE DATA,” and no sound will be heard.
fig.042-043
4. To select a different part, use the [CURSOR] buttons to move the cursor to the part number, and
turn the [VALUE] knob to select a part.
fig.042-0044
Sample nameCursor (underline)
Sample number Part number
Dark
Cursor (underline)
Sample number
Cursor (underline)