User guide

118
VariOS Menu Reference
STEPD (step direction): This function reverses the direction
of the step. When using this, set the Playback Mode (p. 63, p.
113) to STEP. As long as you do not press the pedal, each key
you play (each note-on that is received) will cause playback
to continue to the next event, and then stop. If you play a key
while holding down the pedal, the previous region divided
by events will sound. If you hold down the pedal from the
beginning and play a note, the sound will begin from the last
region of the sample.
fig.R05-034-exp
This can also be used together with EVENT. For details refer
to the explanation of EVENT.
PO/SO (poly/solo)
: The Key Assign Mode (p. 62, p. 113)
setting will be switched temporarily as long as you continue
holding down the pedal. For example if you are playing a
vocal sample in solo mode, you can hold down the pedal to
play a chord.
LOCKL (lock legato): Regardless of how you are playing the
keyboard, notes will be sounded as legato while you hold
down the pedal. This means that you can use this function to
play legato chords.
* You can play legato chords even if the Playback Mode (p. 63,
p. 113) is set to RETRIGGER.
3-2 Knob Assign
C1–C3
Here you can specify the controller numbers that will be output when
you turn the C1–C3 knobs. If the controller numbers you specify here
are received at the MIDI IN connector, the result will be the same as
when the corresponding knob is turned.
Available Settings: CC02–CC05, CC07–CC31, CC64–CC95
VC
This parameter lets you use an external MIDI controller as a fourth
knob. When the controller number you specify here is received at the
MIDI IN connector, the function you assigned in 3-1-4 VC will be
controlled.
Available Settings: CC02–CC05, CC07–CC31, CC64–CC95
* VC stands for Virtual Controller.
3-3 Knob Output Mode
Specifies the destination(s) to which control change messages will be
sent when you turn the C1–C3 knobs.
Available Settings:
3-4 Knob Control
Specifies the part(s) that will be affected when you turn the C1–C3
knobs.
Available Settings:
1
1
2
2
3
3
4
4
5
5
6
6
.......
.......
Wave
start
Wave
end
When you press
the hold pedal:
When you don't press
the hold pedal:
OFF:
Control changes will not be sent; the
knobs will have no effect.
INT:
Control changes will be sent only to
the internal sound generator.
MIDI:
Control changes will be sent only to
the MIDI OUT connector.
INT&MIDI:
Control changes will be sent both to
the internal sound generator and to
the MIDI OUT connector.
MULTI PART: All six parts will be affected.
CURRENT PART:
Only the currently selected part
(the “current part”) will be af-
fected.