User guide

77
Editing in the Phrase Scope
The phrase scope will open when you double-click a green frame that was pasted with the sample’s
“Keyboard Map” (p. 60) set to (Phrase Map).
fig.03-ps01e
● Waveform display area
The waveform of the encoded sample is displayed here. When you edit notes or time, the results will
appear in this area. You cannot directly edit the waveform in the waveform display area.
* If the waveform is not displayed, try using the scroll bar located at the right of the waveform display area
to adjust the displayed area (upward or downward).
fig.03-ps02e
If you play from the middle of a phrase, the sound will be heard starting at the
location of an event (blue line).
About pitches in the waveform display area
•For samples encoded in the SOLO type, the waveform will be displayed at the
positions of the notes.
•Pitches in the waveform display area are only approximate, and may not be
accurate for some samples.
•For samples encoded in a type other than SOLO, the entire waveform will be
displayed at the same pitch.
● Note display area
The notes corresponding to the waveform display area are shown here. You can use these notes to edit
the pitches of the phrase. To edit a note, select a tool from the tool buttons.
● Controller display area
In this area you can edit the PITCH, TIME, FORMANT, DYNAMICS, and VELOCITY parameters. Use
the [Controller select] buttons at the left to select the parameter you want to edit. Edit the selected
parameter by using the mouse to drag the curve directly.
Waveform
display area
Controller
display area
Note display
area
Auto scrollTool buttonsModify record
Curve
select
Time keep
Reset
curve
Curve view
Time zero input
Grid snap Quantize
Ruler
Sample data Zoom tool
Controller
select
Events (blue)