Owner's manual

18
Track Operations
This unit includes eight tracks used for creating performance data, including the KICK, SNARE, HI-HAT, KIT, BASS, INST 1, INST 2 and VOCAL tracks.
There are four types of tracks, and the type of data that a track can contain depends on its track type.
Selecting Tracks
1. Press a track button from [KICK] through [VOCAL] to select a
track.
* To select the VOCAL track, press the [SONG] button to set the workow to
“SONG.”
The buttons of selected tracks light up.
Making Track Settings
This shows how to adjust the volume, equalizer and other parameters
for each track.
1. Press the [MIXER] button.
The track mixer screen appears.
2. Press a track button from [KICK] through [VOCAL] to select
the track to adjust.
* To select the VOCAL track, press the [SONG] button to set the workow to
“SONG.”
3. Use the [VALUE] dial to display the parameter you want
to adjust, and use the [CTRL 1]–[CTRL 3] knobs to edit the
values.
Parameter Value Explanation
LOW -24–+24
Adjusts the amount of boost/cut for the low, mid and
high ranges.
* When adjusting the equalizer, make sure that the
equalizer is turned on in the detailed track settings
(
&
memo).
MID -24–+24
HI -24–+24
LEV 0–127 Adjusts the volume.
PAN L128–127R Adjusts the sound position (pan).
MUT OFF, MUTE Sets mute on or o.
DLY -127–127 Sets how much signal is sent to the delay.
REV -127–127 Sets how much signal is sent to the reverb.
4. Press the [EXIT] button to close the track mixer screen.
MEMO
5 You can also turn the mute feature on/o by holding down the [MIXER]
button and pressing the [KICK]–[VOCAL] buttons.
5 Detailed track settings
Press the [KICK]–[VOCAL] buttons while holding down the [SHIFT] button to
access more detailed settings.
&For details, see the “Parameter Guide” (PDF).
Editing the Track Type
There are four types of tracks: “tone,” “drum kit,” “looper” and “vocal”
(p. 9). Change the track type to suit your needs.
The track types that can be set for each track are shown below.
Track
Settings when making
a new project
Track type
Tone Drum Kit Looper
Vocal
KICK Tone
( (
— —
SNARE Tone
( (
— —
HI-HAT Tone
( (
— —
KIT Drum Kit
( (
— —
BASS Tone
( (
— —
INST 1 Tone
( ( (
—
INST 2 Tone
( ( (
—
VOCAL Vocal — — —
(
* The VOCAL track is for vocals only. You cannot change its type.
NOTE
To change the type of a track, delete the existing track and then create a new
track. If the track contains clips that you need, save the clips to an SD card
(p. 21) and then change the track type.
1. While holding down the [CLEAR] button, press the [KICK]–
[INST 2] buttons to select the track to change.
A conrmation message appears.
* To cancel the operation, press the [EXIT] button.
2. Use the [VALUE] dial to select “OK,” and then press the
[VALUE] dial.
The track is deleted, and the CREATE screen appears.
3. Use the [VALUE] dial to select the track type, and then press
the [VALUE] dial.
A new track is created.