Owner`s manual

Mixing Operations

Now let’s do some mixing. This chapter describes two-channel – stereo –

mixing of connected sources that will be sent out from the system through

its MAIN OUT jacks.

Setting the Input Gain

Let’s adjust the input gain levels of all of your connected instruments and so

on. (If you are working on digital connected sources, you do not have to

read this section.)

fig.107

Press [PREAMP GAIN].

[PREAMP GAIN] lights and the “PREAMP GAIN” display appears.

fig.206

Owner’s Manual “Gain,

Phantom Power Supply,

Phase and Attenuator”

(p.68)

As preset at the factory, all

channel numbers on the

console correspond to the

input numbers on the

processor. You may,

however, change the

channels’ connections or

work on multiple channels

at once (Owner’s Manual

“Selecting an input

channel’s signal source”

p.67).

If you selected DIGITAL IN

A/B as your source input,

these steps will not be

necessary.

You can also set the gain

level with the cursor and

knobs on the display.