Owner`s manual

4
Getting Started
How to Use The QUICK START
The QUICK START basically explains the operations as follows:
• For further information to operations or functions, read your console’s and processor’s
Owner’s Manuals.
26
Mixing Operations
Now let’s do some mixing. This chapter describes two-channel – stereo –
mixing of connected sources that will be sent out from the system through
its MAIN OUT jacks.
Setting the Input Gain
Let’s adjust the input gain levels of all of your connected instruments and so
on. (If you are working on digital connected sources, you do not have to
read this section.)
fig.107
1
Press [PREAMP GAIN].
[PREAMP GAIN] lights and the “PREAMP GAIN” display appears.
fig.206
Owner’s Manual “Gain,
Phantom Power Supply,
Phase and Attenuator”
(p.68)
As preset at the factory, all
channel numbers on the
console correspond to the
input numbers on the
processor. You may,
however, change the
channels’ connections or
work on multiple channels
at once (Owner’s Manual
“Selecting an input
channel’s signal source”
p.67).
If you selected DIGITAL IN
A/B as your source input,
these steps will not be
necessary.
2
1
You can also set the gain
level with the cursor and
knobs on the display.
Keys or knobs used in
the corresponding Step
number.
The display mainly used
during the operation.
Step number in the setup procedure.
Reference page for
detailed information to
this section.
Important notifications to
prevent considerable
damage to your
equipment.
Other convenient
setup operations.
Additional suppllemental
remarks.