Owner`s manual

Using Sub Outputs

Flex Bus

Each mixing processor provides 12 unique multi-purpose busses– these are

called “Flex Busses.” A bus – be it a Flex Bus or traditional recording, mixing

or Aux bus – is a pathway down which multiple signals can be sent to a

common destination. The signals assigned to a Flex Bus can be sent out of

the system through various outputs, or can even be directed into another

Flex Bus within the system. This allows you to send signals through external

signal processors or internal effects, or to monitors for performers on the

stage or in the studio.

Let’s start by assigning Flex Busses to outputs.

You may couple a pair of

adjacent Flex Busses and

use them as stereo Flex

Busses (QUICK START:

p.36).

Example 1

You may wish to use reverb on some channels before sending them to the

Main out mix. Route them to a Flex Bus connected to the desired effect.

Example 2

You can record to individual tracks on an 8 track multi-track recorder by

assigning your input channels to any of eight Flex Busses, and using the

MULTI OUTs or ASSIGNABLE OUTs to send each Flex Bus to one of the

eight tracks on the recorder.

Example 3

Since you can adjust each channel’s send level to a Flex Bus, you can create

up to eight separate, fully controllable stage monitor mixes using eight Flex

Busses routed to ASSIGNABLE OUTs 1-8.