Owner`s manual

44
Using Sub Outputs
Flex Bus Output (MULTI OUT/ASSIGNABLE OUT)
Each of the Flex Bus signal can be routed to a MULTI OUT/ASSIGNABLE
OUT. You can send its signal to multi-track recorders, external signal
processors, or to stage monitors, for example.
The MULTI OUTs are primarily used for 24 channel digital recording
outputs – which calls for an additional purchased VM-24E – but can also be
routed to ASSIGNABLE OUT jacks for analog output.
fig.117
1
Press [FLEX BUS MASTER 1-12].
If you wish to edit Flex Busses 9-12, proceed to Step 4.
2
Hold down [CH EDIT] on the channel strip numerically
corresponding to the Flex Bus you wish to edit, and press
[MAIN/CUE].
The “MAIN/CUE” editing page on the “CH EDIT” display appears.
Owner’s Manual
“Outputting signals
directly from a Flex Bus”
(p.86), “Routing Signals to
MULTI OUTs and
ASSIGNABLE OUT Jacks”
(p.93)
35 34
12
6