Owner`s manual

Using On-Board Effects

In this system, there are two internal effects available to the Input and Multi

In channels, and an additional effect provided for the Main out and

monitors. In addition, you can install optional VS8F-2 Effects Expansion

Boards – sold separately – allowing the system to produce up to nine effects

simultaneously from a single mixing processor (see list below).

• FX-1, FX-2 - Pre-installed

• FX-3, FX-4 - VS8F-2 (optional) installed to EFFECT A inside the

processor

• FX-5, FX-6 - VS8F-2 (optional) installed to EFFECT B inside the

processor

• FX-7, FX-8 - VS8F-2 (optional) installed to EFFECT C inside the

processor

• MASTER FX - Pre-installed. Only for MASTER OUT and monitors.

On using the effects, the following steps will be necessary.

1. Make a decision as to where you wish to insert an effect.

You may insert the effect on a Flex Bus to create a send-return loop effect,

or directly on an input channel.

2. To create a send-return loop effect, send the signals to which you wish to

apply the effect to a Flex Bus that is routed to the Main out.

3. Select the desired effect.

Each input also has its own feedback-type delay that produces a delay effect

without using the on-board effect.

Now, let’s add some effects to your signals.

Read OWNER’S MANUAL

for the Processor

“Installing Effects

Processors (VS8F-2)” (p.13)

to learn about the

installation of the VS8F-2.