Owner`s manual

52
Using On-Board Effects
2
Press CURSOR [UP] [DOWN] to select the FX field.
FX-1-3 are located in the upper field, FX-4-6 in the middle, and FX-7-8 in the
lower. If you have not installed an optional VS8F-2, you can only select FX-
1 or FX-2.
3
Press [F2], [F4], or [F6] to “EDIT” the effect.
The “EFFECT (1-8)” editing display appears.
4
Press [PAGE DOWN] to go to the “ASSIGN” page.
At this point, you set the insertion point of the effect.
fig.216
5
Press CURSOR [UP] [DOWN] to select L or R.
6
Turn [V4](SEND LEVEL) to adjust the level to be sent into the
effect, and [V5](RETURN LEVEL) to adjust the effect’s output
level.
The setting’s range is 0 to 127, with no boost or cut applied to the gain (0dB)
at 100.
7
Turn [V2](POSITION) to select “SEND/RTN”
The effect is automatically assigned to its like-numbered Flex Bus.
Flex Bus channel to which an effect is inserted.
Flex Bus channel to which an effect is not inserted.