Owner`s manual

78
Using EZ Routing Templates
5
Set the input gain of each signal on the console.
1. Press [INPUT].
2. Press [PREAMP GAIN].
3. Use the faders to adjust the input gain level of each source.
• If you are using any condenser microphones, activate their
PHANTOM power.
6
Adjust each EQ as necessary.
1. Press [CH EDIT] on the desired channel.
2. Press [PAGE UP] [PAGE DOWN] to select the “EQ BAND” page.
3. Use CURSOR [UP] [DOWN], [V1]-[V6] and [F1]-[F6] to set the EQ.
7
Set the channel levels.
1. Press [CH LEVEL].
2. Adjust each channel’s output level using its fader.
8
Set up the monitors.
• Flex Bus 9-12 signals can be sent out of the system via the FLEX BUS
OUT 9-12 jacks. You can send and balance the signals sent to
FlexBusses 9-12 according to the performers’ needs.
• You can monitor the overall sound through the MONITOR OUT.
• The Talkback signal is assigned to Channel 24.
• You can also send a rough mix into a DAT or MD from the
MONITOR OUT.
• Adjust the live elements’ signals (E. Bass, E. Guitar, Acoustic Guitar,
Choruses 1-3, Lead Vocal) at [MULTI IN] 1-8 Channels.
Owner’s Manual “Gain,
Phantom Power Supply,
Phase and Attenuator”
(p.68)
Owner’s Manual
“Adjusting Various
Channel Settings
(Equalizer, etc.)” (p.78)
Owner’s Manual “Setting
up ON/OFF, SEND LEVEL
and PAN for a Channel”
(p.70)
Owner’s Manual “Mixing
Procedure 2 (Output and
Monitor)” (p.84)