Owner's manual
8
Troubleshooting
With a video device as the master, the
VS-2480/2480CD does not respond
• The cable connected to the L-connector, the SYSTEM E
connector or the MIDI cable is not properly connected.
• The MIDI cable is broken.
• The EXT indicator is off (“SYNC MODE” is set to
“INT”).
• “MMC MODE” (MMC mode) is not set to “SLAVE.”
• The MTC frame rate of the video device differs from that
of the SI-80SP (Roland Video MIDI Sync Interface), or the
video and the VS-2480/2480CD are not set to the same
type of MTC.
• MTC reception is in poor condition.
→
Setting the
ERROR LEVEL
to “5” or higher may
improve conditions.
Other problems
Data on the disk drive was not saved
properly
• The VS-2480/2480CD’s power was turned off without
performing the shutdown process.
• The power was turned off while the disk drive was
operating.
• A strong shock was applied to the disk drive.
• The disk drive or SCSI cable was connected or
disconnected while the power was still turned on.
→
Remake partition the disk drive (and also execute
physical formatting). Also, we recommend that you
execute Surface Scan as well.
2480v2_app_e.book 8 ページ 2006年2月7日 火曜日 午後3時33分