User`s manual

ZCL-540 Setting Z-Axis Origin
NOTES:
 Connect sensor cable to Z-Origin sensor.
•Failing to measure the length
of the tool or performing this
ste
p
will cause the machine to

If you have an Automatic Tool Changer (ATC),
p
cut too deep in the material or
not cut the material at all.

If you have an Automatic Tool Changer (ATC),
install at least one tool, and measure the length of
the tool.
 Install a tool in the spindle or if you have an ATC unit,
pick up a tool whose length has been measured.