Installation guide

INSTALLATIONREQUIREMENTS
'i_'s
Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and water
inlet hoses:
• Pliers that open to 19/16" • Flashlight (optional)
(3.95 cm)
Parts supplied:
Alternate Parts
Your installation may require additional parts. For ordering
information, please refer to the toll-free phone numbers on the
front page of the Washer User Instructions.
If You Have: You Will Need to Buy:
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
A. Drain hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and leveling
the washer:
• Adjustable or open end • Wood block
wrench %d' (14 mm) • Ruler or measuring tape
• Level
Parts supplied:
A B
A. Beaded tie strap
B. Front leveling feet with nuts (2)
1" (2.5 cm) 11/4"(3.2 cm) diameter to 1" (2.5 cm)
diameter diameter standpipe adapter,
standpipe Part Number 280130
Overhead sewer Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Floor drain Siphon break kit, Part Number 280129;
additional drain hose,
Part Number 3357090
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008
Drain hose too Kit Part Number 280131
short
Lint clogged drain Drain protector, Part Number 367031