Instruction manual

Control Application
UltraVista Plus Installation and Operations Manual 7
UltraVista Plus Control Application
Application Installation
Note: Do not connect the UltraVista Plus to the controlling computer’s USB
port until the driver installation is complete.
Locate the Install folder on the supplied CD and run the install.exe program.
The installation is a standard windows type installation, follow the installation
wizard instructions. During installation a warning message is displayed
stating that the driver does not have Windows® Logo accreditation. Select
Continue Anyway to complete the installation.
The UltraVista Plus can now be connected to a suitable USB 1.0 or 2.0 port
using the cable supplied. At this point the hardware will be detected by
Windows as an UltraVista Plus splitter, and a New Hardware wizard is
displayed. Allow the wizard to search, and click on the recommended option
to enable the previously installed driver to be associated with the new
hardware.
Press Continue Anyway to accept the driver.
Running the Control Application
To open the Control Application select Start/All Programs/Control.
The application will search for an UltraVista Plus connected to your
computer and display the status of the first unit detected. If more than one
UltraVista Plus is connected, a list of all available UltraVista Plus’s can be
found in the File menu.
Figure 3. Control Application