Operation Manual

- 20 -
Assembly Instructions
Step A:
Install the Front stabilizer (2) and Rear stabilizer (3) to
the Main frame (1) with the Allen bolts (14) and Flat
washers (13) as shown. Please make sure that the
Leveler feet are on the bottom and the transportation
wheels are facing up and towards the front of the
bike.
Attach the Water bottle holder (19) to the frame with
the Screws (17), and then put on the Water bottle
(20).
Note:
The Leveler feet (11) under the stabilizers can be
adjusted to keep the equipment stable.
Step B:
Attach the Handlebar (4) to the Handlebar post (26),
secured with the Allen bolts (23), Spring washers
(24), and Flat washers (13).
Slide the Lower cover (25B) to the Handlebar post, fi t
the Top cover (25A), and then locked the Cover with
Phillips screws (27) as shown.
Turn and loosen the Knob (8), pull the pin, and then
insert the Handlebar assembly into the Main frame
section simultaneously at a proper height. Make sure
the pop-pin settles into the desired hole and then
secure the Knob.
Step C:
Fit the Saddle (7) on the Seat slider (6) with wrench.
Insert the Seat slider (6) to the Seat post (5), secured
with the Knob (8).
Turn and loosen the Knob (8) on the main frame
section, pull the pin, and then insert the Seat post (5)
into the Main frame (1) simultaneously. Make sure
the pin settles into the desired hole and then secure
the Knob.
Note:
The position of saddle is Horizontal & Vertical
adjustable by the both Knob (8). Please make sure
that the Saddle (7) was securely fastened before
getting on the Bike.