Owner’s Manual Manuel d’utilisation Bedienungsanleitung Manuale di Istruzioni Manual de Instrucciones Gebruiksaanwijzing RB-1050 Stereo Power Amplifier Amplificateur De Puissance Stéréo Stereo-Endstufe Amplificatore di Potenza Etapa de Potencia Estereofónica Stereo Eindversterker POWER AMPLIFIER RB1050 POWER CH-2 LEVEL CH-1 LEVEL CH-1 CH-2 CLIPPING PROTECTION CLIPPING
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: T O REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. APPLICABLE FOR USA, CANADA OR WHERE APPROVED FOR THE USAGE CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. INSERT FULLY. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND.
English 3 Figure 1: Controls and Connections Commandes et branchements Bedienelemente und Anschlüsse Controlli e collegamenti Controles y Conexiones De bedieningsorganen en aansluitingen 4 5 4 POWER AMPLIFIER RB-1050 PROTECTION CH-2 CLIPPING CH-2 LEVEL CH-1 LEVEL CH-1 CLIPPING POWER 3 1 2 3 10A CAUTION SPEAKER IMPEDANCE RISK OF ELECTRIC SHOCK DO NOT OPEN 4 OHMS MINIMUM 12V TRIGGER 12V TRIG.
RB-1050 Stereo Power Amplifier 4 Contents About Rotel Figure 1: Controls and Connections Figure 2: Preamp Input and Speaker Output Connections 3 3 About Rotel .......................................... 4 Getting Started ..................................... 4 A Few Precautions Placement 4 4 AC Power and Control ...........................
English 5 AC Power and Control AC Power Input Because of its high power rating, the RB-1050 can draw considerable current. Therefore, it should be plugged directly into a 2-pin polarized wall outlet. Do not use an extension cord. A heavy duty multi-tap power outlet strip may be used if it (and the wall outlet) is rated to handle the current demanded by the RB-1050 and all the other components connected to it. Be sure the Power Switch on the front panel of the RB-1050 is turned off (in the out position).
RB-1050 Stereo Power Amplifier Input Signal Connections See Figure 2 The RB-1050 has conventional RCA type input connectors, the type found on nearly all audio equipment. NOTE: To prevent loud potentially damaging noises, make sure the amplifier is turned off when you make any changes to the input signal configuration. Select high quality audio interconnect cables. Connect each of the outputs from the preamplifier or signal processor to the corresponding input of the RB-1050.
English 7 Troubleshooting Most difficulties in audio systems are the result of poor or wrong connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RB-1050, refer to the suggestions for the following conditions: Front Panel Power Indicator Is Not Lit No main power to the RB-1050. Check the front panel power switch.
The Rotel Co. Ltd. 10-10 Shinsen-Cho Shibuya-Ku Tokyo 150-0045 Japan Phone: +81 3-5458-5325 Fax: +81 3-5458-5310 Rotel of America 54 Concord Street North Reading, MA 01864-2699 USA Phone: +1 978-664-3820 Fax: +1 978-664-4109 Rotel Europe Meadow Road Worthing, West Sussex BN11 2RX England Phone: +44 (0)1903 524 813 Fax: +44 (0)1903 524 831 Rotel Deutschland Kleine Heide 12 D-33790 Halle/Westf. Germany Phone: +49 05201-87170 Fax: +49 05201-73370 www.rotel.