User manual

10
GB
When the soldering iron is heated up for the for the first time a ‘new’ smell may be produced.
For this reason ensure that you heat the soldering up for the first time only in a well ventilated
place.
- Fit the soldering iron holder (3) to the soldering
stand (2) before you use the soldering iron for
the first time. Start by inserting the soldering
iron holder’s locating pin A into the the slot
provided in the stand’s housing B.
- After sliding the soldering iron holder (3) as
far as it will go into the hole, turn it clockwise
to fix it in place.
BEFORE USING THE SOLDERING IRON
- For convenience the cleaning sponge (5) can be placed in the space provided on the soldering
stand (2). Moisten the soldering sponge (5) slightly before use.
- The soldering stand (2) is equipped with two adjustable workpiece holding clamps (7), which
are handy when working an wires and similar workpieces.
A
B
The soldering iron is designed for use with single phase alternating current 230 V AC / 50 Hz
and is double-insulated. Make certain that the rated voltage stated on the soldering irons’s
rating plate matches the local mains voltage.
MAINS CONNECTION
- Connect the soldering iron to the mains to switch it on and to heat it up.
- Disconnect the soldering iron from the mains to switch it off and to cool it down.
Caution:
The soldering iron, the soldering tip and the soldering iron holder remain
hot for some time after disconnection from the mains!
SWITCHING ON AND OFF
1500000041_Anleitung 07.09.2011 14:14 Uhr Seite 10