User manual

- If the soldering iron is used for longer periods we recommend that you clean the tip

occasionally with the cleaning sponge (5) and re-tin the tip if necessary.

Use a de-soldering braid (not supplied) to clean the joint, to de-solder and to remove excess

solder from the joint. Place the de-soldering braid over the excess solder and heat it with

the soldering tip (6). The molten solder flows on to the de-soldering braid.

- The soldering iron must be stored in the soldering iron holder (3) on the soldering stand (2)

during breaks in your work.

- After you finish soldering disconnect the soldering iron from the mains and allow it to cool

down in the soldering iron stand (3).

Caution:

The soldering iron, the soldering tip and the soldering iron holder remain

hot for some time after disconnection from the mains!

This symbol indicates that this product may not be disposed of together with domestic

waste in compliance with the (2002/96/EC) Regulation pertaining to waste electrical and

electronic devices (WEEE). This product must be handed in at an designated collection

point. This can occur, for example, by returning it when a similar product is purchased

or by handing it in at an authorised collecting point for the recycling of waste electrical

and electronic equipment. Owing to potentially hazardous substances that are frequently

contained in waste electronic equipment, incorrect handling of waste equipment may

have a negative impact on the environment and on the health of human beings. By

disposing of this product correctly, you are also contributing towards an efficient use

of natural resources. Information on collecting points for waste equipment can be

obtained from your local authority, the public waste disposal authority, an authorised

institution for the disposal of waste electrical and electronic equipment or the waste

collection services.

RECYCLING

1500000041_Anleitung 07.09.2011 14:14 Uhr Seite 12