User guide

12. Remove the nylon bushing from the end of the stock lower gear selector and install the bushing on the Rough
Country straight gear selector. See Photo 13.
13. Place the Rough Country gear selector into the transmission, insert the spring and cap. Push down on the cap
and turn clockwise to lock into place. See Photo 14.
14. Install the rubber dust boot back onto the transmission.
15. Lightly grease the outside edges of the lower gear selector.
16. Install the shifter plate to the transmission tunnel and the transfer case gate using factory hardware and a 8mm
socket.
17. Slide the shifter over the top of the lower gear selector and install the lower shifter boot with the 4 factory bolts.
Use a 8mm socket to tighten.
18. Insert the 12V power supply back into the console and slide the console over the shifters into place. Make sure
you pull the shifter boot through the console before the console is all the way down into place.
19. Use a 10mm socket to reinstall all the factory console bolts.
20. Snap the shifter boot back into place and make a test run shifting through each gear.
Photo 13 Photo 14
Thank you for choosing Rough Country for your suspension needs.