Manualshelf

Instruction Manual

ManualsBrandsRough Country ManualsCar1057
1234
INSTALLATION INSTRUCTIONS
1. Place vehicle on a flat surface and set emergency brake.
2. Remove the front bumper end caps as shown in Photo 1 & Photo 2 using a 10mm wrench and remove the cap from
the bumper.
3. Remove the bumper as shown in Photo 3 by removing the bolts using a T30 torx head bit wrench.
4. Remove the bumper bolts ( three per side) as shown in Photo 4 from the uni-body using a 15mm socket.
5. Remove the rear most bumper bolt from the uni-body using a T55 torx bit. See Photo 5.
6. Remove the bumper from the vehicle.
7. Install the bumper bracket on the frame as shown with the 7/16” x 4” bolts, washers and lock nuts on the driver side.
See Photo 6. Do not tighten until all bolts have been installed.
Photo 1 Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Remove bumper caps Remove bumper caps
Remove bumper hardware
Remove bumper hardware
Remove bumper brackets
Install 7/16” x 4” bolts / hardware