Manual

Thank you for choosing Rough Country for your suspension needs.

Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure

you have all the needed parts and understand where they go.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility, that

seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur.

Braking performance and capabilities are decreased when significantly larger/heaver tires and wheels are used. Take

this into consideration while driving. Also, speedometer recalibration is necessary when larger tires are installed.

Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height of

the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts

voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims.

We will not be responsible for any product that is altered.

NOTICE TO DEALER AND VECHICLE OWNER

Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor

or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling character-

istics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation in-

structions on too the vehicle owner for review and to be kept in the vehicle for its service life.

1. Park vehicle on a clean, level surface and block the wheels for safety.

2. Raise the front (or rear if installing rear kit) of the vehicle.

3. Place jack stands under the frame rails and lower the axle onto the jack stands to remove pressure from shackle

assemblies.

4. Remove the stock bolts that secure the stock shackle to the frame and retain stock hardware. Due to the limited

clearance with the gas tank, it may be necessary to cut the stock bolt from the upper shackle mount. See

Photo1.

5. Remove the stock shackles.

6. Using the floor jack lower the axle to allow for the installation of the new lifted Rough Country boomerang shackles.

PARTS LIST

2-Assembled Shackles

1-Poly bag:

4-bolts

4-nuts

8-washers

92RC0400

INSTALLATION INSTRUCTIONS

REAR INSTALLATION SHOWN

BOOMERANG SHACKLE KIT

PHOTO 1

PHOTO 2

PAGE 1
92RC0400 BOOMERANG SHACKLE KIT Thank you for choosing Rough Country for your suspension needs. Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure you have all the needed parts and understand where they go. PRODUCT USE INFORMATION As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility, that seat belts and shoulder harnesses should be worn at all times.
PAGE 2
7. Install the new Rough Country shackles using the supplied hardware as shown. If shackle or spring bushings need to be replaced do so at this time. Leave hardware loose. See Photo 2. 8. Jack up the vehicle and remove the jack stands. Lower the vehicle to the ground. 9. Bounce the vehicle to settle suspension. Tighten the uppers and lower bolts to 30-35 ft-lbs. POST INSTALLATION 1. Check all fasteners for proper torque.