Safety instructions

VOLTAGE

• Before using for the first time, check that the voltage of your mains supply is the same as that shown on the

appliance and that your mains supply is suitable for the power indicated on the appliance.

ASSEMBLING

• Your appliance is supplied unassembled.

It is essential to assemble it correctly. To reduce the risk of fire, electric shock, and injury to persons, this fan must be

installed according to this instruction.

• You must set and use your appliance in compliance with the standards in force in your country.

USER SERVICING INSTRUCTIONS

Fused plug

This plug is a safety feature. It contains a safety device (fuse) that should not be removed. Discard product if the at-

tachment plug is damaged.

To reduce the risk of fire, electric shock and personal injury, do not remove, replace, repair or tamper with the

originally supplied plug.

If the fan does not function properly, it may be due to the safety device incorporated in this plug.

If the fuse fails, it is generally due to a short circuit or circuit overload. Replace the fuse as per the instructions below.

If the replacement fuse fails, immediately unplug the unit and contact Rowenta consumer services for assistance.

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug

is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

Fuse replacement :

1 - To replace the fuse, first turn the unit off and unplug it from the wall. Do not unplug by pulling on cord. Locate the

fuse cover on the top of the plug. (A)

2 - Open the fuse (B) by sliding the fuse cover on the top of the plug towards the blades.

3 - Remove fuse (C) carefully by gently prying out the ends of the fuse from the receptacle.

Warning! Only replace with a fuse type and rating matching what was removed from the product.

4 - Risk of fire. Replace the fuse only with 2,5 Amp, 125 Volt fuse. Gently install replacement fuse back into the pins

that will hold it in place. (D)

Note : If the fuse is not seated properly, the unit will not function.

5 - Close fuse cover (E) by sliding the fuse cover back over the fuse box in the plug until it is completely closed.

6 - Plug the fan back in and resume use.

APPLIANCE(S) WITH REMOTE CONTROL (VU/VF555x; VU/VF5670 ; VU/VF266X):

VU/VF555x: The remote control uses 2 x 1.5 V type AAA or LR03 alkaline batteries, which are not included.

VU/VF567x: The remote control uses 1 x 3V button cell (CR2032) which is not included.

VU/VF266x: The remote control uses 1 x 3V button cell (CR2032) which is not included.

Place the batteries in their compartment making sure that you put them in with the positive and negative ends the

right way round as shown in the battery compartment.

IMPORTANT: You are advised to switch off and unplug the appliance when not in use. When storing the appli-

ance for a longer period of time, please remove the batteries from the remote control.

IN THE EVENT OF PROBLEMS

• Never dismantle your appliance yourself. A poorly repaired appliance may be dangerous for the user.

ABCDE