Technical data

33
Operation
GB
1. Attach the desired nozzle ZChapter 2.2, "Assembly" or
ZChapter 2.3, "Using further nozzles (accessories)".
2. Pull out the cord by the plug up to the yellow mark
(Fig. 9/1).
3. Insert the mains plug into a socket with ground/safety
contact.
4. Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 9/4).
5. Set the nozzle switch to "carpet" or "hard floor"
according to the floor (Fig. 10) to be cleaned:
- Hard floor (Fig. 10/A):
Laminate, tiles, PVC, etc.
- Carpet (Fig. 10/B):
for carpets, runners, etc.
6. Set the suction power with the suction controller
(Fig. 11/1).
7. When working with the cylinder vacuum cleaner, pull if
after you like a sleigh.
WARNING:
Danger of electric shock! If the red marking (Fig. 9/2)
shows, retract the cord by pressing the cord retracting
button (Fig. 9/3) to pull in the cord up to the yellow mark
again. Otherwise the power cord might break.
WARNING:
Danger of injury or fire! Only operate the appliance if your
mains voltage is the same as that indicated on the
appliance's nameplate. Wrong voltage can cause short-
circuiting and possibly a subsequent fire.
NOTE:
With the bypass vent (Fig. 12/1) you can quickly reduce
the suction power if less power is needed, or to release
objects accidentally sucked in.
Fig. 9
1
2
3
4
Fig. 10
B
A
Fig. 11
1
Fig. 12
1
02_Centrixx TS_gb.book Seite 33 Donnerstag, 2. April 2009 12:38 12