Technical data

Cleaning and care

8. On this occasion, also take out the motor protection

filter (Fig. 23/1).

9. Tap the dirt out of this filter over a dustbin. as well.

10. If these filter elements are damaged or too dirty for wet

cleaning, replace them by new ones(ZChapter 5.2,

"Spare parts").

11. Put the new or cleaned motor protection filter element

back in place.

12. Lock the central laminar filter onto the dust container

cover again by turning it clockwise (Fig. 25). Make sure

it is fitted correctly as otherwise the filter screen will not

lock into place.

13. Insert the filter screen again by turning it clockwise

(Fig. 26).

14. Push the cover onto the dust container again. When

attaching it, make sure the nose engages the

corresponding groove.

15. Place the dust container back into the cylinder vacuum

cleaner and turn it to the left (Fig. 27).

16. Close the housing cover (Fig. 27). The release buttons

must click shut audibly. Check that the housing cover is

fitted securely.

NOTE:

If the motor protection filter element (Fig. 24/1), the

central laminar filter element (Fig. 24/2) and the filter

screen (Fig. 24/3) are still dirty after thorough dry

cleaning, thoroughly rinse them with cold water (Fig. 24).

Do not use detergents or brushes with hard bristles for

this task. Then leave the filter elements to dry (approx.

15 hours at room temperature). Only put them back into

the appliance when they are completely dry.

Fig. 23

Fig. 24

Fig. 25

Fig. 26

Fig. 27

02_Centrixx TS_gb.book Seite 38 Donnerstag, 2. April 2009 12:38 12