Use and Care Manual

18
4. Unscrew the 4 bolts holding the faceplate to the body (on the front edge where your cooking grate sits).
5. Unscrew the 2 bolts (on each side) of the manifold and faceplate assembly that holds this entire assembly
to the body of the grill.
6. Disconnect all wires and flex lines, from the valves and igniter assembly while paying close attention to their
original location.
7. Slide entire control panel and valve assembly out from the grill body.
8. Flip control panel over on its side, so you have easy access to the valves.
9. Sear Burner Grills Only – Remove center knob, unscrew top and bottom screws only.
a. The safety valve that controls the thermocouple on your sear burner must be completely changed.
You cannot change only the orifice.
10. Sear Burner Grills Only – Unscrew base bracket, hold center valve to gas manifold pipe and remove valve.
11. Sear Burner Grills Only – Install new Safety Valve in the correct gas type and follow the removal instructions
in reverse.
12. Once the panel is flipped over, you will see the orifice at the end of the valve. With a wrench remove the
orifice from the valve and install the new gas orifice,
13. Re-assemble in reverse and test all connections again with a soapy water solution to ensure no leaks.
To convert your rear burner orifice:
1. Remove your entire rotisserie assembly.
2. Remove the back panel that covers your rear rotisserie burner.
a. With the hood open, remove the 4 screws on top of this panel.
b. With the hood closed, remove the 4 screws on the back of this panel.
c. With the hood closed, look underneath this same back panel and you will see 4-5 bolts (depending
on your grill), these only need to be loosened.
3. Next, pull the entire panel (starting from the back) out from the grill
a. It is designed to fit tight, so you may need a flat head screwdriver to pop the stainless away from the
body.
4. Next, you will see the gas line, brass elbow and orifice.
5. Use a wrench to remove the orifice and install the new one.
6. Re-assemble in reverse and check your back burner to ensure proper ignition and burning.
Instruction for Connecting the Transformer
1. Transformer for Interior & LED Lights - Your grill’s electrical transformer will connect on the left side of
your grill (looking at it from the front) and operates the hood lights inside your grill, along with the LED
lights on the SL models. Follow the pictures and insert the white male plug into the white female socket, on
the left side of your grill and then plug the transformer into a standard 110v outlet. If you have any
questions or concerns, please consult or use a qualified electrician.
Left Side of Grills Male Plug Female Socket