International Home Theater System User Manual

Installation
D-73d Series Installation/Operation Manual 31
PRE
L
IMINAR
Y
3.4
Installing the Optional
Anamorphic Lens
Mount
If you are installing a standard D-73d (without an anamorphic lens), skip this step and
proceed with Mounting the D-73d (page 36).
If you are installing a D-73d/CineWide, proceed with Installing the Fixed CineWide
Base Plate (D-73d/CineWide) (page 34).
If you are installing a D-73d/CineWide with AutoScope, proceed as follows to install the
AutoScope lens motor.
Installing the
CineWide/AutoScope
Lens Motor
(D-73d/CineWide with
AutoScope)
Remove Projector Feet: Place the
projector upside down on a blanket or
other soft surface. Loosen and remove
the two front feet on the projector.
1. Do not install the CineWide lenses yet, only the fixed CineWide
base plate or AutoScope lens motor. You will install the
CineWide lenses after you install the projector and adjust the
primary lenses.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
Note
Your D-73d/CineWide with AutoScope may have shipped with the
AutoScope lens motor pre-installed. If so, proceed with
Connecting the AutoScope Lens Motor to the Projector
(page 33).
Note