Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Controls and Functions
Runco VX-2cx/VX-2dcx Owner’s Operating Manual 7
PRE
L
IMINAR
Y
5. CABLE OPENING
Pass cables through this opening.
6. VERTICAL LENS SHIFT ADJUSTMENT
7. HORIZONTAL LENS SHIFT ADJUSTMENT
2.2
VX-2 Rear Panel
Figure 2-3 shows the VX-2 rear panel.
Figure 2-3. VX-2 Rear Panel
1. VACUUM FLUORESCENT DISPLAY
Displays currently-selected menu. If no menu is selected, “Runco VX-2” appears here.
2. PROGRAM PORT
For service use only.
3. DHD INPUT
An HDCP-compliant digital video input for connecting the DVI output from the DHD
Controller.
4. POWER BUTTON
Press once to turn on the VX-2. Press it again to put it into Standby mode. For a
discrete on or off command, you can use the direct access buttons on the remote
control.
5. POWER/STANDBY LED
VX-2 DIGITAL PROJECTOR
AC IN
120V 60HZ
ON / OFF
1 2 3 4 5
7 8 13126 119 1410