Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Controls and Functions
8 Runco VX-2cx/VX-2dcx Owner’s Operating Manual
PRE
L
IMINAR
Y
6. LAMP COVER
Remove this cover to access the lamp compartment.
7. UP BUTTON
Used to move the menu cursor up in the VX-2 menu system.
8. LEFT BUTTON
Used to move the menu cursor left in the VX-2 menu system.
9. DOWN BUTTON
Used to move the menu cursor down in the VX-2 menu system.
10. ENTER BUTTON
When an item is highlighted on the On-Screen Display, the ENTER button selects the
item.
11. RIGHT BUTTON
Used to move the menu cursor right in the VX-2 menu system.
12. MENU BUTTON
Pressing the MENU button brings up the main VX-2 menu. Also, if you are in an
adjustment mode or function, pressing MENU brings the menu back one level.
13. POWER INPUT (100 to 240 VAC)
Connect the VX-2 to power here.
14. MAIN POWER SWITCH
Disconnects or applies power to the VX-2.
The VX-2 has its own internal menu system, separate from that of
the DHD Controller. However, it is intended for use by trained
service personnel only.
Note