Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Installation
Runco VX-2cx/VX-2dcx Owner’s Operating Manual 23
PRE
L
IMINAR
Y
Figure 3-4. Horizontal Lens Shift (Example Only)
Vertical Lens Shift - VX-2cx: The VX-2cx zoom lenses (Proteus B through F) provide up
to 80% of downward vertical lens shift. For example, with a 96 x 54-inch (16:9) screen,
you can shift the image up to 43.20 inches (1.10
meters) below the screen center.
(Upward vertical lens shift is not possible. Vertical lens shift is not possible in either
direction with the Proteus A lens.)
Horizontal Lens Shift - VX-2cx: The VX-2cx zoom lenses (Proteus B through F) allow
up to 10% of horizontal lens shift in either direction (left or right). For example, with a
96
x 54-inch (16:9) screen, you can shift the image up to 9.60 inches (24.38 cm) left or
right of the screen center. (Horizontal lens shift is not possible with the Proteus A lens.)
0%
Screen Center
100% Width Lens Shift
(1.0 x W)
50% Width Lens Shift
(0.5 x W)
150% Width Lens Shift
(1.5 x W)
Screen Width (W)
Note: This is a general example of lens shift. Lenses vary in their shift capabilities. No particular
lens or projector is used in this example.