Specifications

Installation
Runco VX-2cx/VX-2dcx Owner’s Operating Manual 27
PRE
L
IMINAR
Y
3.6
Connections to the
VX-2 and DHD
Controller
Proceed as follows to connect the DHD Controller to the VX-2, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel AccessTo access the connector panel, pull firmly on the cable access cover to open it.
Connecting the DHD
Controller to the VX-2
The VX-2 is designed to receive only digital input signals directly from the companion DHD
Controller/Processor. All signal sources should be connected to the appropriate inputs on
the rear panel of the DHD. The signal from the DHD is then output to the VX-2 projector
through a Runco proprietary DVI cable.
Use the supplied cable to connect the DVI Output of the DHD Controller to the DHD Input
of the VX-2; see
Figure 3-6.
Figure 3-6. Connecting the VX-2 to the DHD Controller
You CANNOT connect a signal source with DVI output directly to
the VX-2. It MUST be routed through the DHD Controller for proper
operation.
Note
VX-2 DIGITAL PROJECTOR
AC IN
120V 60HZ
ON / OFF
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1
2
Pr
R
Y
G
Pb
B
R
Pr
G
Y
B
Pb
H
V
DVI 1 DVI 2DVI OutH/VVH
Pr
R
Y
G
Pb
B
H
V
TRIGGERS
RS-232 Out
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARN ING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
OUTPUTS
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Video Processor / Controller
Model
Runco International
Union City, CA
Made In USA