Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Installation
32 Runco VX-2cx/VX-2dcx Owner’s Operating Manual
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the DHD Controller; see
Figure 3-11.
For more information about using this connection, refer to Serial Communications on
page 61.
Figure 3-11. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External
Theater
Equipment
If your VX-2 is equipped with a CineWide with AutoScope system, use the cable supplied
with the AutoScope Lens Motor to connect the motor to a 12-Volt trigger output as
shown in
Figure 3-12.
Figure 3-12. Connecting the 12-Volt Trigger Output to the AutoScope Lens Motor
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
3.5-mm
mini plug
to AutoScope
Lens Motor