Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Maintenance and Troubleshooting
54 Runco VX-2cx/VX-2dcx Owner’s Operating Manual
PRE
L
IMINAR
Y
VX-2cx Lens Replacement 1. Loosen the captive Phillips screw from the
bottom of the front lens decorative bezel.
2. Slide the bezel upward to remove it.
3. Remove the foam shield around the front of the lens.
4. Using the red-handled, 3-mm hex driver
provided with the projector, loosen the
three, captive Allen screws on the outer
ring of the lens assembly.
5. Gently pull the lens assembly straight out,
just far enough to separate the motor
socket connector (on the lens) from the
lens mount flange (inside the projector).
Then, carefully rotate the lens assembly 90
degrees counter-clockwise (in order to
clear the Projector chassis with the Motor
Assembly) and remove it.
➤