Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Maintenance and Troubleshooting
56 Runco VX-2cx/VX-2dcx Owner’s Operating Manual
PRE
L
IMINAR
Y
9. Replace the foam lens shield.
10. Reattach the front lens bezel by sliding the
top down onto the two retaining dowels.
11. Tighten the Phillips screw on the bottom of
the bezel to secure it.
VX-2dcx Lens
Replacement
Figure 5-1 shows the VX-2dcx lens assembly.
Figure 5-1. VX-2dcx Lens Assembly Exploded View
➤
Front of Lens
Motor Assembly
Electrical Connector
and Harness
Projector Front Jewelry
Motor Assembly
9/64” Hex Screw (6x)
for Mounting Lens