Specifications
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional CineWide Lens
- 3.5 Mounting the VX-2
- 3.6 Connections to the VX-2 and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-2
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting to AC Power
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Adjusting the Picture Orientation
- 4.3 Lens Adjustments
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. VX-2 Color Gamut Adjustment
Maintenance and Troubleshooting
Runco VX-2cx/VX-2dcx Owner’s Operating Manual 57
PRE
L
IMINAR
Y
1. Remove the Projector Front Jewelry by
loosening the captive #2 Phillips screw
below the lens.
2. Locate and unplug the Motor Assembly
Connector. Note the connector
orientation for when you install the new
lens.
3. Locate the six 9/64” Hex Mounting
Screws (two each at 12
o'clock,
9
o'clock and 6 o'clock).
4. Remove the six Mounting Screws while
supporting the Lens Assembly; Lens
and Motor Assembly are now free.
5. Remove the Lens and Motor Assembly
by pulling forward and to the left in
order to clear the Projector chassis with
the Motor Assembly.