SDS

Date Printed: 3/15/2017
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if
present and easy to do. Continue rinsing.
P337+P313 If eye irritation persists: Get medical advice/attention.
3. Composition/Information On Ingredients
HAZARDOUS SUBSTANCES
Chemical Name CAS-No. Wt.%
Range
GHS Symbols
GHS Statements
Acetone 67-64-1 25-50 GHS02-GHS07 H225-319-332-336
n-Butyl Acetate 123-86-4 10-25 GHS02-GHS07 H226-336
Propane 74-98-6 10-25 GHS04 H280
n-Butane 106-97-8 2.5-10 GHS04 H280
Titanium Dioxide 13463-67-7 2.5-10 Not Available Not Available
1-Methoxy-2-Propyl Acetate 108-65-6 2.5-10 GHS02 H226
Propylene Glycol Monobutyl Ether 5131-66-8 2.5-10 GHS07 H302-315-319
Ethanol 64-17-5 0.1-1.0 GHS02 H225
Stoddard Solvent 8052-41-3 0.1-1.0 GHS08 H304-372
4. First-aid Measures
FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical
attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the
lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-fighting Measures
EXTINGUISHING MEDIA: Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN 20°F. EXTREMELY FLAMMABLE LIQUID AND
VAPOR!Water spray may be ineffective. Closed containers may explode when exposed to extreme heat due to buildup of steam.
Closed containers may explode when exposed to extreme heat. Vapors may form explosive mixtures with air. Vapors can travel to a
source of ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame. Perforation of the pressurized
container may cause bursting of the can. No unusual fire or explosion hazards noted. Keep containers tightly closed.
SPECIAL FIREFIGHTING PROCEDURES: Full protective equipment including self-contained breathing apparatus should be used.
Evacuate area and fight fire from a safe distance. Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Remove
all sources of ignition, ventilate area and remove with inert absorbent and non-sparking tools. Dispose of according to local, state
(provincial) and federal regulations. Do not incinerate closed containers. Ventilate area, isolate spilled material, and remove with
inert absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations.
Page 2 / 6