MSDS

ManualsBrandsRust-Oleum Industrial Choice ManualsPaint18 oz. Yellow Inverted Striping Spray Paint (6-Pack)

Date Printed: 9/28/2012

Naphtha, Petroleum,

Hydrotreated Light

64742-49-0 10.0 200 mg/m3 N.E. N.E. N.E.

Acetone 67-64-1 5.0 500 ppm 750 ppm 1000 ppm N.E.

Titanium Dioxide 13463-67-7 5.0 10 mg/m3 N.E.

15 mg/m3 [Total

Dust]

N.E.

Mineral Spirits 64742-88-7 5.0 100 ppm N.E. 100 ppm N.E.

Xylene 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.

Solvent Naptha, Light Aromatic 64742-95-6 5.0 N.E. N.E. N.E. N.E.

1,2,4-Trimethylbenzene 95-63-6 5.0 25 ppm N.E. N.E. N.E.

Ethylbenzene 100-41-4 1.0 20 ppm 125 ppm 100 ppm N.E.

Amorphous Silica 7631-86-9 1.0 N.E. N.E. 0.8 mg/m3 N.E.

Ethylene Glycol Monobutyl

Ether

111-76-2 1.0 20 ppm N.E. 50 ppm N.E.

Neodecanoic Acid, Cobalt Salt 27253-31-2 0.1 0.2 mg/m3 N.E. N.E. N.E.

4. First-aid Measures4. First-aid Measures

FIRST AID FIRST AID

EYE CONTACT: EYE CONTACT:

Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID FIRST AID

SKIN CONTACT: SKIN CONTACT:

Wash with soap and water. Get medical attention if irritation develops or persists.

FIRST AID FIRST AID

INHALATION: INHALATION:

If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is

experienced, get medical assistance immediately.

FIRST AID FIRST AID

INGESTION: INGESTION:

Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the

lungs and cause severe lung damage. Get immediate medical attention.

5. Fire-fighting Measures5. Fire-fighting Measures

Flash Point, °F -156 (Setaflash)

EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Water Fog

UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN 20 °. F. - EXTREMELY FLAMMABLE LIQUID AND

VAPOR! Water spray may be ineffective. Closed containers may explode when exposed to extreme heat. Vapors may form

explosive mixtures with air. Vapors can travel to a source of ignition and flash back. Keep containers tightly closed. Isolate from

heat, electrical equipment, sparks and open flame. Perforation of the pressurized container may cause bursting of the can.

SPECIAL FIREFIGHTING PROCEDURES: Evacuate area and fight fire from a safe distance.

6. Accidental Release Measures

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use

combustible materials such as sawdust. Remove all sources of ignition, ventilate area and remove with inert absorbent and non-

sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not incinerate closed containers.

7. Handling and Storage

HANDLING: Wash thoroughly after handling. Wash hands before eating. Use only in a well-ventilated area. Follow all MSDS/label

precautions even after container is emptied because it may retain product residues. Avoid breathing vapor or mist.

STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Do not store above

120 ° F. Store large quantities in buildings designed and protected for storage of NFPA Class I flammable liquids. Contents under

pressure. Do not expose to heat or store above 120 ° F.

8. Exposure Controls/Personal Protection

Page 2 / 5