Specification Sheet

TECHNICAL DATA ATO-64
FABRIC & VINYL
Form: GDH-117
Rev.: 052517
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Fabric & Vinyl is a flexible coating that restores
color on vinyl, simulated leather and some fabrics. This vinyl
coating provides excellent adhesion that will not rub off, crack or
peel. It is suitable for use on car seats, car door panels,
dashboards, floor mats and other interior surfaces. Fabric & Vinyl
features an advanced spray system that allows you to spray at
any angle, even upside down for those hard to reach areas. A
comfort spray tip with a wider finger pad reduces fatigue caused
by continuous spraying.
.PRODUCTS .
SKU (11 ounce spray) Description
248918 Gloss Black
248919 Flat Black
248920 Gray
248921 Sand
248922 Gloss White
248923 Gloss Red
248924 Gloss Blue
248925 Burgundy
248926 Silver
249307 Medium Blue
249308 Charcoal
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 85% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or galvanized metal. Avoid spraying in very windy
and dusty conditions. Cover surrounding area to protect
from spray mist.
..PRODUCT APPLICATION (cont.) .
SURFACE PREPARATION
Clean surface with soap and water, rinse and let dry. If
surface was previously treated with conditioners, waxes or
other coatings, additional cleaning is required using either
Rust-Oleum Paint Prep Wipe or mineral spirits. It is
important that all residual coatings be removed from vinyl
surfaces prior to application.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 10-12" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 2 or more light coats a few
minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 10 minutes, to handle in 1 hour and is
fully dry in 24 hours. Wait at least 6 hours before sitting on
or using a painted object.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.