Technical Specifications

2
Form: CS2290
Rev.: 031913
TECHNICAL DATA
COUNTERTOP TRANSFORMATIONS
TM
PRODUCT APPLICATION . .
Watch the entire instructional DVD and use the printed
instructions for the complete, step by step, procedure on
application of the materials.
SURFACE PREPARATION
The surface of the countertop must be completely cleaned
and de-glossed in accordance to the instructions to ensure
proper performance of the Countertop Transformations.
APPLICATION OF BASE COAT
IMPORTANT: Once the Adhesive Base Coat is applied,
you have a 20-minute window to apply the Decorative
Color Chips before the Adhesive Base Coat dries. Follow
the printed instructions.
APPLICATION OF WETTING AGENT
The Wetting Agent keeps the Adhesive Base Coat wet
longer and improves the adhesion of the Decorative Color
Chips.
IMPORTANT: Only use Wetting Agent on Adhesive Base
Coat. Do not use with Protective Top Coat. Avoid getting
Wetting Agent on painted surfaces, appliances, cabinets
or countertops that have not been coated with Adhesive
Base Coat.
APPLICATION OF DECORATIVE CHIPS
Decorative Chips need to be dispersed quickly over the
entire surface of the countertop before the Adhesive Base
Coat dries. By the time you have finished, the entire
countertop, backsplash, and front edge should be
completely covered with Decorative Chips. Once the
Decorative Chips have been applied, DO NOT TOUCH
the countertop until the coated surface has dried overnight
(a minimum of 12 hours). After the countertop has dried
for a minimum of 12 hours, sand the surface smooth prior
to application of the topcoat.
APPLICATION OF THE TOPCOAT
The topcoat is a special two component clear modified
silicone epoxy finish. This protective finish is low odor and
does not require any special ventilation. Following
application, allow the Protective Top Coat to dry
undisturbed, taking steps to make sure the countertop is
not touched or brushed up against. Keep windows closed,
pets away, and ceiling fans off.
IMPORTANT: Contents of Protective Top Coat are
combustible until applied to the surface. Extinguish all
flames and pilot lights, and turn off stoves, heaters,
electric motors and other sources of ignition during use
until project is complete. Keep away from heat, sparks and
flame. Do not smoke.
The countertop is ready for light use in 48 hours and full
use after 7 days.