Use and Care Manual

EPOXYSHIELD
®
1-PART CONCRETE PAINT
TECHNICAL DATA
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature do not constitute
a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we can guarantee these products only
to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All technical information is subject to change without notice.
Form: CS1077
Rev.: 061812
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
An RPM Company
Phone: 877
•
385
•
8155
www.rustoleum.com/industrial
®
PHYSICAL PROPERTIES
1-PART CONCRETE PAINT
Resin Type
Modified Acrylic Copolymer
Pigment Type
Varies with color
Solvents
Dipropylene Glycol Monobutyl Ether, Water
Weight*
Per Gallon
10.30-10.70 lbs.
Per Liter
1.23-1.28 kg
Solids*
By Weight
46.8-50.4%
By Volume
34.1-35.7%
Volatile Organic Compounds*
<250g/l (2.08 lbs./gal.)
Mixing Ratio
None
Recommended Dry Film
Thickness (DFT) Per Coat
3.0-3.5 mils (75-87.5µ)
Wet Film to Achieve DFT
(Unthinned Material)
6.0-7.0 mils (150-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
844-847 sq.ft./gal.
(20.7-20.8 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
200-240 sq.ft./gal.
(4.9-5.9 m
2
/l)
Dry Times
at 70-80°F
(21-27°C) and
50% Rel. Hum.
Lt. Foot Traffic
12-16 hours
Foot Traffic
24 hours
Vehicle Traffic
7 days
Shelf Life
5 years
Safety
Information
Flash Point
>200°F (93°C)
Contains
—
Warning!
FOR ADDITIONAL INFORMATION, SEE MSDS.
Calculated values may vary slightly from the actual manufactured material.
*Activated material.