Use and Care Manual

TECHNICAL DATA
SPC-66
RUST-OLEUM
®
SPECIALTY
FARM & IMPLEMENT ENAMELS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com/specialty
Form: GDH-959
Rev.: 060519
PHYSICAL PROPERTIES
FARM & IMPLEMENT ENAMELS
Resin Type
Oil Modified Alkyd
Pigment Type
Varies with color
Solvents
Mineral Spirits
Weight
Per Gallon
7.67-7.81 lbs.
Per Liter
0.92-0.94 kg
Solids
By Weight
48.2-48.9%
By Volume
38.2-38.8%
Volatile Organic Compounds
<500 g/l (4.20 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
2.5-5.0 mils
(62.5-125µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
520 sq.ft./gal. (12.8 m
2
/l)
130 sq.ft./quart (3.2m
2
/l)
Dry Times at 70-80ºF
(21-27ºC) and 50%
Relative Humidity
Touch
2-4 hours
Handle
5-9 hours
Recoat
24 hours (allow more time at cooler temperatures)
Dry Heat Resistance
212°F (100°C)
Shelf Life
5 years
Flash Point
104°F (40°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.