Operating instructions

Page 100 Power Equipment Usage Manual (Rev. 5/10)
19.2.10. Starting & Stopping the Motor
CAUTION: Before starting the router make sure bit is clear of workpiece and
foreign objects. Also keep firm grip on router to resist starting torque.
The motor is started and stopped by setting the toggle switch (A)
Figure 14 to “ON” or “OFF” position.
CAUTION: To avoid personal injury or damage to finished work always
allow the motor to come to a COMPLETE STOP before setting it down.
CAUTION: When through-cutting, be sure there is clearance under
workpiece for router bit.
19.2.11. Using the Router
CAUTION: Always be sure the work is rigidly clamped or
otherwise secured before making a cut.
Before using your router, consider the kind and total amount of material to be removed. Depending on
the material, it may be necessary to make more than one cut to avoid overloading the motor. Before
beginning the cut on the actual workpiece, it is advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look as well as enable you to check dimensions.
Generally speaking, when working on a bench, the workpiece should be held on the bench by wood
clamps. When routing edges, the router must be held firmly down and against the work by both guiding
knobs.
Since the cutter rotates clockwise (when viewing router from top), the router should be moved from
left to right (counter-clockwise) as you stand facing the work. Always route any end grain first.
• When working on the inside of a template, move router in clockwise direction (Figure 15).
• When working on the outside of a template, move router in a counter clockwise direction
(Figure 15).
Route End Grain First
Should Start Here
Fig. 14
Fig. 15